epic100.h

Go to the documentation of this file.

#ifndef _EPIC100_H_
# define _EPIC100_H_

FILE_LICENCE ( GPL2_OR_LATER );

#ifndef PCI_VENDOR_SMC
# define PCI_VENDOR_SMC         0x10B8
#endif

#ifndef PCI_DEVICE_SMC_EPIC100
# define PCI_DEVICE_SMC_EPIC100 0x0005
#endif

#define PCI_DEVICE_ID_NONE      0xFFFF

/* Offsets to registers (using SMC names). */
enum epic100_registers {
    COMMAND= 0,         /* Control Register */
    INTSTAT= 4,         /* Interrupt Status */
    INTMASK= 8,         /* Interrupt Mask */
    GENCTL = 0x0C,      /* General Control */
    NVCTL  = 0x10,      /* Non Volatile Control */
    EECTL  = 0x14,      /* EEPROM Control  */
    TEST   = 0x1C,      /* Test register: marked as reserved (see in source code) */
    CRCCNT = 0x20,      /* CRC Error Counter */
    ALICNT = 0x24,      /* Frame Alignment Error Counter */
    MPCNT  = 0x28,      /* Missed Packet Counter */
    MMCTL  = 0x30,      /* MII Management Interface Control */
    MMDATA = 0x34,      /* MII Management Interface Data */
    MIICFG = 0x38,      /* MII Configuration */
    IPG    = 0x3C,      /* InterPacket Gap */
    LAN0   = 0x40,      /* MAC address. (0x40-0x48) */
    IDCHK  = 0x4C,      /* BoardID/ Checksum */
    MC0    = 0x50,      /* Multicast filter table. (0x50-0x5c) */
    RXCON  = 0x60,      /* Receive Control */
    TXCON  = 0x70,      /* Transmit Control */
    TXSTAT = 0x74,      /* Transmit Status */
    PRCDAR = 0x84,      /* PCI Receive Current Descriptor Address */
    PRSTAT = 0xA4,      /* PCI Receive DMA Status */
    PRCPTHR= 0xB0,      /* PCI Receive Copy Threshold */
    PTCDAR = 0xC4,      /* PCI Transmit Current Descriptor Address */
    ETHTHR = 0xDC       /* Early Transmit Threshold */
};

/* Command register (CR_) bits */
#define CR_STOP_RX              (0x00000001)
#define CR_START_RX             (0x00000002)
#define CR_QUEUE_TX             (0x00000004)
#define CR_QUEUE_RX             (0x00000008)
#define CR_NEXTFRAME            (0x00000010)
#define CR_STOP_TX_DMA          (0x00000020)
#define CR_STOP_RX_DMA          (0x00000040)
#define CR_TX_UGO               (0x00000080)

/* Interrupt register bits. NI means No Interrupt generated */

#define INTR_RX_THR_STA         (0x00400000)    /* rx copy threshold status NI */
#define INTR_RX_BUFF_EMPTY      (0x00200000)    /* rx buffers empty. NI */
#define INTR_TX_IN_PROG         (0x00100000)    /* tx copy in progess. NI */
#define INTR_RX_IN_PROG         (0x00080000)    /* rx copy in progress. NI */
#define INTR_TXIDLE             (0x00040000)    /* tx idle. NI */
#define INTR_RXIDLE             (0x00020000)    /* rx idle. NI */
#define INTR_INTR_ACTIVE        (0x00010000)    /* Interrupt active. NI */
#define INTR_RX_STATUS_OK       (0x00008000)    /* rx status valid. NI */
#define INTR_PCI_TGT_ABT        (0x00004000)    /* PCI Target abort */
#define INTR_PCI_MASTER_ABT     (0x00002000)    /* PCI Master abort */
#define INTR_PCI_PARITY_ERR     (0x00001000)    /* PCI adress parity error */
#define INTR_PCI_DATA_ERR       (0x00000800)    /* PCI data parity error */
#define INTR_RX_THR_CROSSED     (0x00000400)    /* rx copy threshold crossed */
#define INTR_CNTFULL            (0x00000200)    /* Counter overflow */
#define INTR_TXUNDERRUN         (0x00000100)    /* tx underrun. */
#define INTR_TXEMPTY            (0x00000080)    /* tx queue empty */
#define INTR_TX_CH_COMPLETE     (0x00000040)    /* tx chain complete */
#define INTR_TXDONE             (0x00000020)    /* tx complete (w or w/o err) */
#define INTR_RXERROR            (0x00000010)    /* rx error (CRC) */
#define INTR_RXOVERFLOW         (0x00000008)    /* rx buffer overflow */
#define INTR_RX_QUEUE_EMPTY     (0x00000004)    /* rx queue empty. */
#define INTR_RXHEADER           (0x00000002)    /* header copy complete */
#define INTR_RXDONE             (0x00000001)    /* Receive copy complete */

#define INTR_CLEARINTR          (0x00007FFF)
#define INTR_VALIDBITS          (0x007FFFFF)
#define INTR_DISABLE            (0x00000000)
#define INTR_CLEARERRS          (0x00007F18)
#define INTR_ABNINTR            (INTR_CNTFULL | INTR_TXUNDERRUN | INTR_RXOVERFLOW)

/* General Control (GC_) bits */

#define GC_SOFT_RESET           (0x00000001)
#define GC_INTR_ENABLE          (0x00000002)
#define GC_SOFT_INTR            (0x00000004)
#define GC_POWER_DOWN           (0x00000008)
#define GC_ONE_COPY             (0x00000010)
#define GC_BIG_ENDIAN           (0x00000020)
#define GC_RX_PREEMPT_TX        (0x00000040)
#define GC_TX_PREEMPT_RX        (0x00000080)

/*
 * Receive FIFO Threshold values
 * Control the level at which the  PCI burst state machine
 * begins to empty the receive FIFO. Possible values: 0-3
 *
 * 0 => 32, 1 => 64, 2 => 96 3 => 128 bytes.
 */
#define GC_RX_FIFO_THR_32       (0x00000000)
#define GC_RX_FIFO_THR_64       (0x00000100)
#define GC_RX_FIFO_THR_96       (0x00000200)
#define GC_RX_FIFO_THR_128      (0x00000300)

/* Memory Read Control (MRC_) values */
#define GC_MRC_MEM_READ         (0x00000000)
#define GC_MRC_READ_MULT        (0x00000400)
#define GC_MRC_READ_LINE        (0x00000800)

#define GC_SOFTBIT0             (0x00001000)
#define GC_SOFTBIT1             (0x00002000)
#define GC_RESET_PHY            (0x00004000)

/* Definitions of the Receive Control (RC_) register bits */

#define RC_SAVE_ERRORED_PKT     (0x00000001)
#define RC_SAVE_RUNT_FRAMES     (0x00000002)
#define RC_RCV_BROADCAST        (0x00000004)
#define RC_RCV_MULTICAST        (0x00000008)
#define RC_RCV_INVERSE_PKT      (0x00000010)
#define RC_PROMISCUOUS_MODE     (0x00000020)
#define RC_MONITOR_MODE         (0x00000040)
#define RC_EARLY_RCV_ENABLE     (0x00000080)

/* description of the rx descriptors control bits */
#define RD_FRAGLIST             (0x0001)        /* Desc points to a fragment list */
#define RD_LLFORM               (0x0002)        /* Frag list format */
#define RD_HDR_CPY              (0x0004)        /* Desc used for header copy */

/* Definition of the Transmit CONTROL (TC) register bits */

#define TC_EARLY_TX_ENABLE      (0x00000001)

/* Loopback Mode (LM_) Select valuesbits */
#define TC_LM_NORMAL            (0x00000000)
#define TC_LM_INTERNAL          (0x00000002)
#define TC_LM_EXTERNAL          (0x00000004)
#define TC_LM_FULL_DPX          (0x00000006)

#define TX_SLOT_TIME            (0x00000078)

/* Bytes transferred to chip before transmission starts. */
#define TX_FIFO_THRESH          128     /* Rounded down to 4 byte units. */

/* description of rx descriptors status bits */
#define RRING_PKT_INTACT        (0x0001)
#define RRING_ALIGN_ERR         (0x0002)
#define RRING_CRC_ERR           (0x0004)
#define RRING_MISSED_PKT        (0x0008)
#define RRING_MULTICAST         (0x0010)
#define RRING_BROADCAST         (0x0020)
#define RRING_RECEIVER_DISABLE  (0x0040)
#define RRING_STATUS_VALID      (0x1000)
#define RRING_FRAGLIST_ERR      (0x2000)
#define RRING_HDR_COPIED        (0x4000)
#define RRING_OWN               (0x8000)

/* error summary */
#define RRING_ERROR             (RRING_ALIGN_ERR|RRING_CRC_ERR)

/* description of tx descriptors status bits */
#define TRING_PKT_INTACT        (0x0001)        /* pkt transmitted. */
#define TRING_PKT_NONDEFER      (0x0002)        /* pkt xmitted w/o deferring */
#define TRING_COLL              (0x0004)        /* pkt xmitted w collisions */
#define TRING_CARR              (0x0008)        /* carrier sense lost */
#define TRING_UNDERRUN          (0x0010)        /* DMA underrun */
#define TRING_HB_COLL           (0x0020)        /* Collision detect Heartbeat */
#define TRING_WIN_COLL          (0x0040)        /* out of window collision */
#define TRING_DEFERRED          (0x0080)        /* Deferring */
#define TRING_COLL_COUNT        (0x0F00)        /* collision counter (mask) */
#define TRING_COLL_EXCESS       (0x1000)        /* tx aborted: excessive colls */
#define TRING_OWN               (0x8000)        /* desc ownership bit */

/* error summary */
#define TRING_ABORT     (TRING_COLL_EXCESS|TRING_WIN_COLL|TRING_UNDERRUN)
#define TRING_ERROR     (TRING_DEFERRED|TRING_WIN_COLL|TRING_UNDERRUN|TRING_CARR/*|TRING_COLL*/ )

/* description of the tx descriptors control bits */
#define TD_FRAGLIST             (0x0001)        /* Desc points to a fragment list */
#define TD_LLFORM               (0x0002)        /* Frag list format */
#define TD_IAF                  (0x0004)        /* Generate Interrupt after tx */
#define TD_NOCRC                (0x0008)        /* No CRC generated */
#define TD_LASTDESC             (0x0010)        /* Last desc for this frame */

#endif  /* _EPIC100_H_ */